Body Control System With intelligent key system
B2562 low voltage
In this manual: Body Control System With intelligent key system
~1min read
DTC Logic
DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE
1.DTC CONFIRMATION 1. Erase DTC. 2. Turn ignition switch OFF.3. Perform the “Self Diagnostic Result” of BCM with CONSULT-III, when passed 120 seconds or more after the ignition switch is turned ON.
Is any DTC detected? YES >> Refer to BCS-86, "Diagnosis Procedure".
NO >> INSPECTION END
Diagnosis Procedure
1.CHECK POWER SUPPLY CIRCUITCheck BCM power supply circuit. Refer to BCS-87, "Diagnosis Procedure".
Is the circuit normal? YES >> Replace BCM. Refer to BCS-93, "Removal and Installation".
NO >> Repair the malfunctioning part.
Was this page helpful?