Heater & Air Conditioning Control System Type 2
B27B0 A/C auto AMP.
In this manual: Heater & Air Conditioning Control System Type 2
~1min read
DTC Logic
DTC DETECTION LOGIC
NOTE:• If DTC is displayed along with DTC U1000, first perform the trouble diagnosis for DTC U1000. Refer to HAC- 141, "DTC Logic".
• If DTC is displayed along with DTC U1010, first perform the trouble diagnosis for DTC U1010. HAC-142, "DTC Logic".

DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE
With CONSULT-III
1. Turn ignition switch ON. 2. Select “Self Diagnostic Result” mode of “HVAC” using CONSULT-III.
3. Check DTC.
Is DTC detected? YES >> Refer to HAC-161, "Diagnosis Procedure".
NO >> INSPECTION END
Diagnosis Proc
1.PERFORM SELF DIAGNOSTIC
With CONSULT-III
1. Turn ignition switch ON. 2. Select “Self Diagnostic Result” mode of “HVAC” using CONSULT-III. 3. Touch “ERASE”. 4. Turn ignition switch OFF. 5. Turn ignition switch ON.
6. Perform “DTC CONFIRMATION PROCEDURE”. Refer to HAC-161, "DTC Logic".
Is DTC detected again? YES >> Replace A/C auto amp. Refer to HAC-188, "Removal and Installation".
NO >> INSPECTION END
Was this page helpful?