Blower fan on signal
Component Function Check
1.CHECK BLOWER FAN ON SIGNAL
With CONSULT-III
1. Turn ignition switch ON. 2. Select “AIR CONDITIONER” of “BCM” using CONSULT-III. 3. Select “FAN ON SIG” in “DATA MONITOR” mode.
4. Check blower fan ON signal when the fan switch is operated.

Is the inspection result normal? YES >> INSPECTION END
NO >> Refer to HAC-168, "Diagnosis Procedure".
Diagnosis Procedure
1.CHECK BLOWER FAN ON SIGNAL 1. Turn ignition switch OFF. 2. Disconnect A/C auto amp. harness connector. 3. Turn ignition switch ON.4. Check output waveform between A/C auto amp. and ground with using oscilloscope.

Is the inspection result normal? YES >> Replace A/C auto amp. Refer to HAC-188, "Removal and Installation".
NO >> GO TO 2.
2.CHECK BLOWER FAN ON SIGNAL CIRCUIT FOR OPEN 1. Turn ignition switch OFF. 2. Disconnect BCM connector.3. Check continuity A/C auto amp. harness connector and BCM harness connector.

Is the inspection result normal? YES >> GO TO 3.
NO >> Repair harness or connector.
3.CHECK BLOWER FAN ON SIGNAL CIRCUIT FOR SHORTCheck continuity between A/C auto amp. harness connector and ground.

Is the inspection result normal? YES >> Replace BCM. Refer to BCS-93, "Removal and Installation" (with Intelligent Key) or BCS-161, "Removal and Installation" (without Intelligent Key).
NO >> Repair harness or connector.