Power supply and ground circuit
Check symptom (A or B).

Which symptom is detected? A >>GO TO 2.
B >>GO TO 5.
2.CHECK FUSE 1. Turn ignition switch OFF.2. Check 10A fuse (No. 3, located in fuse block (J/B)].
NOTE:
Refer to PG-22, "Fuse, Connector and Terminal Arrangement".
Is the inspection result normal? YES >> GO TO 3.
NO >> Replace the blown fuse after repairing the affected circuit if a fuse is blown.
3.CHECK A/C AUTO AMP. IGNITION POWER SUPPLY 1. Disconnect A/C auto amp. connector. 2. Turn ignition switch ON.3. Check voltage between A/C auto amp. harness connector and ground.

Is the inspection result normal? YES >> GO TO 4.
NO >> Repair harness or connector between A/C auto amp. and fuse.
4.CHECK A/C AUTO AMP. GROUND CIRCUIT FOR OPEN 1. Turn ignition switch OFF.2. Check continuity between A/C auto amp. harness connector and ground.

Is the inspection result normal? YES >> Replace A/C auto amp. Refer to HAC-188, "Removal and Installation".
NO >> Repair harness or connector.
5.CHECK FUSE 1. Turn ignition switch OFF.2. Check 10A fuse (No.7, located in fuse block (J/B)].
NOTE:
Refer to PG-22, "Fuse, Connector and Terminal Arrangement".
Is the inspection result normal? YES >> GO TO 6.
NO >> Replace the blown fuse after repairing the affected circuit if a fuse is blown.
6.CHECK A/C AUTO AMP. BATTERY POWER SUPPLY 1. Disconnect A/C auto amp. connector.2. Check voltage between A/C auto amp. harness connector and ground.

Is the inspection result normal? YES >> Replace A/C auto amp. Refer to HAC-188, "Removal and Installation".
NO >> Repair harness or connector between A/C auto amp. and fuse.