Door motor
:
If all of door motor DTCs are detected, check this circuit.
2. Check voltage between intake door motor harness connector and ground.

Is the inspection result normal? YES >> GO TO 2.
NO >> GO TO 7.
2.CHECK DOOR MOTOR GROUND CIRCUIT FOR OPEN 1. Turn ignition switch OFF. 2. Disconnect intake door motor and A/C auto amp. connector.3. Check continuity between intake door motor harness connector and A/C auto amp. harness connector.

Is the inspection result normal? YES >> GO TO 3.
NO >> Repair harness or connector.
3.CHECK DOOR MOTOR LIN SIGNAL 1. Connect A/C auto amp. and intake door motor connector. 2. Turn ignition switch ON.3. Confirm output waveform between A/C auto amp. harness connector and ground using oscilloscope.

Is the inspection result normal? YES >> GO TO 4.
NO >> GO TO 6.
4.CHECK DOOR MOTOR LIN SIGNAL CIRCUIT FOR OPEN 1. Turn ignition switch OFF. 2. Disconnect A/C auto amp. and intake door motor connector.3. Check continuity between A/C auto amp. harness connector and intake door motor harness connector.

Is the inspection result normal? YES >> GO TO 5.
NO >> Repair harness or connector.
5.CHECK INTERMITTENT INCIDENTCheck intermittent incident. Refer to GI-42, "Intermittent Incident".
>> INSPECTION END
6.CHECK DOOR MOTOR LIN SIGNAL CIRCUIT FOR SHORT 1. Turn ignition switch OFF.2. Disconnect following connectors.
- A/C auto amp.- Air mix door motor
- Mode door motor
- Intake door motor
3. Check continuity between A/C auto amp. harness connector and ground.

Is the inspection result normal? YES >> Replace A/C auto amp. Refer to HAC-188, "Removal and Installation".
NO >> Repair harness or connector.
7.CHECK DOOR MOTOR POWER SUPPLY CIRCUIT FOR OPEN 1. Turn ignition switch OFF. 2. Disconnect intake door motor and A/C auto amp. connector.3. Check continuity between intake door motor harness connector and A/C auto amp. harness connector.

Is the inspection result normal? YES >> GO TO 8.
NO >> Repair harness or connector.
8.CHECK DOOR MOTOR POWER SUPPLY CIRCUIT FOR SHORT 1. Disconnect following connectors.- Air mix door motor
- Mode door motor
2. Check continuity between A/C auto amp. harness connector and ground.

Is the inspection result normal? YES >> Replace A/C auto amp. Refer to HAC-188, "Removal and Installation".
NO >> Repair harness or connector.