Engine stand setting
:
Explained here is how to disassemble with engine stand supporting transaxle surface. When using different type of engine stand, note with difference in steps and etc.
• Secure flywheel (M/T models) or drive plate (CVT models) (1) with a stopper plate [SST: KV11105210 (J-44716)] (A), and remove mounting bolts.
CAUTION:• Never disassemble them. • Never place them with signal plate facing down. • When handling signal plate, take care not to damage or scratch them.
• Handle signal plate in a manner that prevents them from becoming magnetized.
NOTE:
This figure shows CVT models as an example.

b. Remove pilot converter (1) using pilot bushing puller [SST: ST16610001 (J-23907)] (A) or suitable tool. (CVT models) NOTE
:
M/T models have no pilot bushing.

c. Lift the engine with a hoist to install it onto widely use engine stand.
CAUTION:• Use the engine stand that has a load capacity [approximately 135 kg (298 lb) or more] large enough for supporting the engine weight. • If the load capacity of stand is not adequate, remove the following parts beforehand to reduce the potential risk of overturning stand. - Intake manifold: Refer to EM-28, "Exploded View". - catalyst convertor: Refer to EM-33, "2WD : Exploded View" (2WD models) or EM-34, "4WD : Exploded View" (4WD models).
- Rocker cover: Refer to EM-53, "Exploded View".
NOTE:
The figure shows an example of widely used engine stand (A) that can support mating surface of transaxle with flywheel (M/T models) or drive plate (CVT models) removed.
CAUTION:Before removing the hanging chains, check the engine stand is stable and there is no risk of overturning.

3. Drain engine oil. Refer to LU-9, "Draining".
CAUTION:Be sure to clean drain plug and install with new drain plug washer.
4. Drain engine coolant by removing water drain plug (1) from inside of the engine.
: Engine front
Tightening torque : Refer to EM-104, "Disassembly and Assembly".
Use Genuine Liquid Gasket or equivalent.