Front washer nozzle and tube
Exploded View
LHD models

1. Front washer nozzle LH 2. Front washer nozzle RH 3. Cowl top cover
4. Front washer tube (tank side) 5. Front washer tube RH 6. Front washer tube LH
: Vehicle front
Hydraulic Layout

1. Front washer nozzle 2. Check valve
3. Front washer
4. Washer tank
: Cli
Removal and Installation
REMOVAL
1. Remove cowl top cover. Refer to EXT-20, "Removal and Installation". 2. Disconnect front washer tube from front washer nozzle.3. While pressing pawl (A) on the cowl top cover front side of front washer nozzle (1), remove front washer nozzle from cowl top cover.

INSTALLATION
Note the following item, and then install in the reverse order of removal.
CAUTION:The spray positions differ, check that left and right nozzles are installed correctly.
Inspection and Adjustment
INSPECTION
Check valve Inspection Check that air can pass through the hose by blowing forward (toward the nozzle (1)), and check that air cannot pass through by sucking.

ADJUSTMENT
Washer Nozzle Spray Position Adjustment Adjust spray positions to match the positions shown in the figure.
LHD models

1. Black printed frame line
: Spray area
: Target spray position

RHD models

1. Black printed frame line
: Spray area
: Target spray position

Insert a needle or similar object (A) into the spray opening (1) and move up/down and left/right to adjust the spray position.
NOTE:
If wax or dust gets into the nozzle, remove wax or dust with a needle or small pin.
