Parking brake switch
Component Function Check
1.CHECK PARKING BRAKE SWITCH OPERATIONOperate the parking brake lever. Then check that the brake warning lamp in the combination meter turns ON/ OFF correctly.
Is the inspection result normal? YES >> INSPECTION END
NO >> Proceed to BRC-208, "Diagnosis Procedure".
Diagnosis Procedure
1.CHECK PARKING BRAKE SWITCH CIRCUIT 1. Turn the ignition switch OFF. 2. Disconnect parking brake switch harness connector. 3. Disconnect combination meter harness connector.4. Check continuity between parking brake switch harness connector and combination meter harness connector.

5. Check continuity between parking brake switch harness connector and ground.

Is the inspection result normal? YES >> GO TO 2.
NO >> Repair or replace error-detected parts.
2.CHECK PARKING BRAKE SWITCHCheck the parking brake switch. Refer to BRC-208, "Component Inspection".
Is the inspection result normal? YES >> GO TO 3.
NO >> Replace parking brake switch. Refer to PB-5, "Removal and Installation".
3.CHECK COMBINATION METERCheck combination meter. Refer to MWI-23, "CONSULT-III Function".
Is the inspection result normal? YES >> Check each pin terminals for damage or loose connection with harness connector. If any items are damaged, repair or replace error-detected parts.
NO >> Repair or replace combination meter. Refer to MWI-69, "Removal and Installation".
Component Inspection
1.CHECK PARKING BRAKE SWITCH 1. Turn the ignition switch OFF. 2. Disconnect parking brake switch harness connector.3. Check continuity between parking brake switch harness connector.

Is the inspection result normal? YES >> INSPECTION END
NO >> Replace parking brake switch. Refer to PB-5, "Removal and Installation".