Rear Suspension 4WD
Rear stabilizer
In this manual: Rear Suspension 4WD
~1min read
Exploded View

1. Stabilizer bar
2. Bushing
3. Stabilizer clamp
4. Stabilizer link
5. Lower link
6. Rear suspension member
disassembly.
: N·m (kg-m, ft-lb)
Removal and Installation
REMOVAL
1. Remove stabilizer link. 2. Remove center pipe. Refer to EX-6, "Removal and Installation". 3. Remove mounting nuts on stabilizer clamp, bushing, and stabilizer bar from suspension member.4. Perform inspection after removal. Refer to RSU-34, "Inspection".
INSTALLATION
Note the following, and install in the reverse order of removal.
• Perform final tightening of rear suspension member and axle installation position (rubber bushing), under unladen conditions with tires on level ground.• Never reuse stabilizer link mounting nut.
Inspection
INSPECTION AFTER REMOVAL
Check stabilizer bar, stabilizer link, stabilizer bushing and stabilizer clamp for deformation, cracks or damage.
Replace it if necessary.
Was this page helpful?