Engine Cooling System K9K
Water pump
In this manual: Engine Cooling System K9K
~1min read
Exploded View

1. Water pump
2. Gasket
3. Cylinder block
Removal and Installation
WARNING:Never remove the radiator cap when the engine is hot. Serious burns could occur from high pressure coolant escaping from the radiator.
REMOVAL
1. Drain engine coolant. Refer to CO-62, "Draining".
CAUTION:Perform when engine is cold. 2. Remove front wheel RH. 3. Remove fender protector (RH). Refer to EXT-22, "Exploded View" 4. Remove drive belt. Refer to EM-276, "Removal and Installation". 5. Remove timing belt and inner cover. Refer to EM-302, "Exploded View".
6. Remove the water pump.
• Coolant will leak from the cylinder block, so have a receptacle ready below.
CAUTION:• Handle the water pump vane so that it does not contact any other parts.
• Water pump cannot be disassembled and should be replaced as a unit.
INSTALLATION
• Install in the reverse order of removal.
Inspection
INSPECTION AFTER REMOVAL
• Visually make sure there is no significant dirt or rusting on the water pump body and vane. • Make sure there is no looseness in the vane shaft, and that it turns smoothly when rotated by hand.• If there are any unusualness, replace the water pump assembly.

INSPECTION AFTER INSTALLATION
• Check for engine coolant leaks using reservoir tank cap tester. Refer to CO-62, "Inspection".
Was this page helpful?