Driver Information & Multimedia

B133a Avm Connection

12steps
~72min
3/5difficulty
Done 0 of 12
DTC Description

DTC DETECTION LOGIC

DTC No.

CONSULT screen terms

(Trouble diagnosis content)
DTC detection condition
B133A-8F

AVM connection

(Camera image signal)
Diagnosis condition When ignition switch is ON.
Signal (terminal) Camera image signal circuit (terminal 49)
Threshold —
Diagnosis delay time —

POSSIBLE CAUSE

  • Camera image signal circuit

  • Around view monitor control unit

  • AV control unit

FAIL-SAFE

Camera image is inoperative

DTC Confirmation Procedure

PERFORM DTC CONFIRMATION PROCEDURE

CONSULT

  1. Ignition switch ON.

  2. Ignition switch OFF and wait at least 30 seconds.

  3. Ignition switch ON and wait at least 30 seconds or more.

  4. Select “Self Diagnostic Result” mode of “MULTI AV”.

  5. Check DTC.

Is DTC B133A–8F detected?

YES>>

Refer to DTC Diagnosis Procedure.

NO>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO>>

Confirmation after repair: Inspection End.

DTC Diagnosis Procedure

CHECK CAMERA IMAGE SIGNAL CIRCUIT FOR OPEN

  1. Ignition switch OFF.

  2. Disconnect AV control unit connector and around view monitor control unit connector.

  3. Check the continuity between AV control unit connector and around view monitor control unit connector.

    AV control unitAround view monitor control unitContinuity
    ConnectorTerminalConnectorTerminal
    M162 49 M96 4 Yes

Is the inspection result normal?

YES>>

GO TO 2.

NO>>

Repair harness or connector.

CHECK CAMERA IMAGE SIGNAL CIRCUIT FOR SHORT

Check the continuity between AV control unit connector and ground.

(+)(−)Continuity
AV control unit
ConnectorTerminal
M162 49 Ground No

Is the inspection result normal?

YES>>

GO TO 3.

NO>>

Repair harness or connector.

CHECK CAMERA IMAGE SIGNAL

  1. Connect AV control unit connector and around view monitor control unit connector.

  2. Ignition switch ON.

  3. Shift the selector lever to “R” position

  4. Check the signal between AV control unit connector and ground.

    AV control unit( - )ConditionReference value
    ( + )
    ConnectorTerminal
    M162 49 Ground Camera image is displayed

Is the inspection result normal?

YES>>

Replace AV control unit. Refer to Removal and Installation.

NO>>

Replace around view monitor control unit. Refer to Removal and Installation.