Driver Information & Multimedia

B1383 Incomp Steering Angle Sensor Adjust

5steps
~30min
2/5difficulty
Done 0 of 5
DTC Description

DTC DETECTION LOGIC

DTC No.

CONSULT screen terms

(Trouble diagnosis content)
DTC detection condition
B1383–01

Incomp steering angle senor adjust

(Steering angle sensor calibration)
Diagnosis condition When ignition switch is ON.
Signal (terminal) —
Threshold —
Diagnosis delay time —

POSSIBLE CAUSE

  • Neutral position adjustment of the steering angle sensor is incomplete

  • Steering angle sensor

FAIL-SAFE

Predictive course line is not displayed

Confirmation Procedure

PERFORM DTC CONFIRMATION PROCEDURE

CONSULT

  1. Ignition switch ON.

  2. Ignition switch OFF and wait at least 30 seconds.

  3. Ignition switch ON and wait at least 30 seconds or more.

  4. Select “Self Diagnostic Result” mode of “MULTI AV”.

  5. Check DTC.

Is DTC B1383 detected?

YES>>

Proceed to DTC Diagnosis Procedure.

NO>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO>>

Confirmation after repair: Inspection End.

DTC Diagnosis Procedure

ADJUST NEUTRAL POSITION OF STEERING ANGLE SENSOR

Adjusts the steering angle sensor neutral position on ABS actuator and electrical unit (control unit) side. Refer to Work Procedure.

>>

GO TO 2.

PERFORM DTC CONFIRMATION PROCEDURE AGAIN

Perform DTC confirmation procedure again. Refer to DTC Confirmation Procedure.

Is DTC B1383 detected again?

YES>>

Replace steering angle sensor. Refer to Removal and Installation.

NO>>

Inspection End.