Driver Information & Multimedia
B13cf Buttons
In this manual: Driver Information & Multimedia
8steps
~48min
2/5difficulty
Done 0 of 8
DTC DETECTION LOGIC
| DTC No. | CONSULT screen terms (Trouble diagnosis content) | DTC detection condition | |
|---|---|---|---|
| B13CF-73 | Buttons (AV control unit) |
Diagnosis condition | When ignition switch is ON. |
| Signal (terminal) | — | ||
| Threshold | — | ||
| Diagnosis delay time | — | ||
POSSIBLE CAUSE
AV control unit
FAIL-SAFE
AV control unit buttons error
PERFORM DTC CONFIRMATION PROCEDURE
CONSULT
Ignition switch ON.
Ignition switch OFF and wait at least 30 seconds.
Ignition switch ON and wait at least 30 seconds or more.
Select “Self Diagnostic Result” mode of “MULTI AV”.
Check DTC.
Is DTC B13CF detected?
YES>>Proceed to DTC Diagnosis Procedure.
NO>>To check malfunction symptom before repair: Refer to Intermittent Incident.
NO>>Confirmation after repair: Inspection End.
PERFORM DTC CONFIRMATION PROCEDURE AGAIN
CONSULT
Ignition switch ON.
Erase DTC.
Perform DTC confirmation procedure again. Refer to DTC Confirmation Procedure.
Is DTC B13CF detected again?
YES>>Replace AV control unit. Refer to Removal and Installation.
NO>>Inspection End.
Was this page helpful?