Electrical & Power Control

B2600-46 Config Error

6steps
~36min
2/5difficulty
Done 0 of 6
DTC Description

DTC DETECTION LOGIC

DTC

Trouble diagnosis

(Trouble diagnosis contents)
Detecting condition
B2600-46

CONFIG ERROR

(Configuration error)
[CALIB/PRMTER MEMORY ERROR] When errors are detected in the configuration data stored in the 3CH CAN gateway.

POSSIBLE CAUSE

3CH CAN gateway

FAIL-SAFE

Transmission and reception of the signal between vehicle CAN communication circuit and diagnostic CAN communication circuit are stopped

DTC CONFIRMATION PROCEDURE

PERFORM DTC CONFIRMATION PROCEDURE

With CONSULT

  1. Turn ignition switch ON and wait at least 2 seconds or more.

  2. Select “Self Diagnostic Result” mode of “3ch CAN GATEWAY” using CONSULT.

  3. Check DTC.

Is DTC B2600-46 detected?

YES>>

Proceed to Diagnosis Procedure.

NO>>

To check malfunction symptom before repair: Intermittent Incident.

NO>>

Confirmation after repair: INSPECTION END

Diagnosis Procedure

PERFORM CONFIGURATION OF 3CH CAN GATEWAY

Perform 3CH CAN gateway Configuration. Refer to Description.

>>

GO TO 2.

PERFORM DTC CONFIRMATION PROCEDURE AGAIN

  1. Turn ignition switch ON.

  2. Perform DTC confirmation procedure again. Refer to DTC Description.

  3. Check DTC.

Is DTC B2600-46 displayed?

YES>>

Replace 3CH CAN gateway. Refer to Removal and Installation.

NO>>

INSPECTION END