Electrical & Power Control

B260a Ignition Relay

10steps
~60min
3/5difficulty
Done 0 of 10
DTC Description

DTC DETECTION LOGIC

DTC No.CONSULT screen terms (Trouble diagnosis content)DTC Detection Condition
B260A

IGNITION RELAY

(Ignition relay)
Diagnosis condition When ignition switch ON.
Signal (terminal) —
Threshold —
Diagnosis delay time 2 seconds or more

POSSIBLE CAUSE

  • Harness or connectors

  • BCM

  • IPDM E/R

FAIL SAFE

—

DTC Confirmation Procedure

PERFORM DTC CONFIRMATION PROCEDURE

CONSULT

  1. Ignition switch ON under the following conditions and wait for at least 2 seconds:

    • CVT selector lever is in the P (park) or N (neutral) position.

    • Release the brake pedal.

  2. Select “Self Diagnostic Result” mode of “BCM”.

  3. Check DTC.

Is DTC detected?

YES>>

Refer to DTC Diagnosis Procedure.

NO>>

Inspection End.

DTC Diagnosis Procedure

CHECK SELF DIAGNOSTIC RESULT

CONSULT

Select “Self Diagnostic Result” mode of “IPDM E/R”.

Are any DTCs detected?

YES>>

Refer to DTC Index.

NO>>

GO TO 2.

CHECK IGNITION RELAY-1 SIGNAL

Check voltage between BCM harness connector and ground.

BCM — Condition

Voltage

(Approx.)
Connector Terminal
M19 70 Ground Ignition switch: ON 0 V

Is the inspection result normal?

YES>>

GO TO 3.

NO>>

GO TO 5.

CHECK IGNITION RELAY-1 POWER SUPPLY

Check voltage between IPDM E/R harness connector and ground.

IPDM E/R — Condition

Voltage

(Approx.)
Connector Terminal
E119 43 Ground Ignition switch: OFF Battery voltage

Is the inspection result normal?

YES>>

Replace BCM. Refer to Removal and Installation.

NO>>

GO TO 4.

CHECK IGNITION RELAY-1 SIGNAL CIRCUIT CONTINUITY

  1. Ignition switch OFF.

  2. Disconnect BCM connector and IPDM E/R connector.

  3. Check continuity between BCM harness connector and IPDM E/R harness connector.

    BCM IPDM E/R Continuity
    Connector Terminal Connector Terminal
    M19 70 E119 43 Yes
  4. Check continuity between BCM harness connector and ground.

    BCM — Continuity
    Connector Terminal
    M19 70 Ground No

Is the inspection result normal?

YES>>

Replace BCM. Refer to Removal and Installation.

NO>>

Repair or replace harness or connectors.

CHECK IGNITION RELAY-1 SIGNAL CIRCUIT

  1. Ignition switch OFF.

  2. Disconnect BCM connector and IPDM E/R connector E119.

  3. Check voltage between BCM harness connector and ground.

    BCM —

    Voltage

    (Approx.)
    Connector Terminal
    M19 70 Ground 0 V

Is the inspection result normal?

YES>>

Replace IPDM E/R. Refer to Removal and Installation.

NO>>

Repair or replace harness or connectors.