Electrical & Power Control

B26f1 Ign Relay Off

11steps
~66min
3/5difficulty
Done 0 of 11
DTC Description

DTC DETECTION LOGIC

DTC No.CONSULT screen terms (Trouble diagnosis content)DTC Detection Condition
B26F1

IGN RELAY OFF

(Ignition relay off)
Diagnosis condition When ignition switch ON.
Signal (terminal) IPDM E/R ignition output 1 (Terminal 70)
Threshold Less than 8.8V or more than 16.5V
Diagnosis delay time 2 seconds or more

POSSIBLE CAUSE

  • Harness or connectors

    (Ignition relay circuit is open)

  • BCM

  • IPDM E/R

FAIL-SAFE

Inhibit engine cranking.

DTC Confirmation Procedure

PERFORM DTC CONFIRMATION PROCEDURE

CONSULT

  1. Ignition switch ON under the following conditions, and wait for 2 seconds or more:

    • CVT selector lever is in the P (park) or N (neutral) position.

    • Do not depress brake pedal.

  2. Select “Self Diagnostic Result” mode of “BCM”.

  3. Check DTC.

Is DTC detected?

YES>>

Refer to DTC Diagnosis Procedure.

NO>>

Inspection End.

DTC Diagnosis Procedure

CHECK SELF DIAGNOSTIC RESULT FOR IPDM E/R

CONSULT

  1. Select “Self Diagnostic Result” mode of “IPDM E/R”.

  2. Erase DTCs.

  3. Ignition switch OFF.

  4. Ignition switch ON.

  5. Select “Self Diagnostic Result” mode of “IPDM E/R”.

Are any DTCs detected?

YES>>

Refer to DTC Index.

NO>>

GO TO 2.

CHECK IGNITION RELAY (IPDM E/R) CONTROL SIGNAL

Check voltage between BCM harness connector and ground.

BCM — Condition

Voltage

(Approx.)
Connector Terminal
M19 70 Ground Ignition switch: ON 0 V

Is the inspection result normal?

YES>>

GO TO 3.

NO>>

Replace BCM. Refer to Removal and Installation.

CHECK IGNITION RELAY (IPDM E/R) CONTROL SIGNAL CIRCUIT

  1. Ignition switch OFF.

  2. Disconnect BCM connector and IPDM E/R connector E119.

  3. Check continuity between BCM harness connector and IPDM E/R harness connector.

    BCM IPDM E/R Continuity
    Connector Terminal Connector Terminal
    M19 70 E119 43 Yes

Is the inspection result normal?

YES>>

Replace IPDM E/R. Refer to Removal and Installation.

NO>>

Repair or replace harness or connectors.