Driver Information & Multimedia

B2724 Sonar Control Unit

9steps
~54min
2/5difficulty
Done 0 of 9
DTC Description

DTC DETECTION LOGIC

DTC No.

CONSULT screen terms

(Trouble diagnosis content)

DTC detection condition
B2724–23

SONAR CONTROL UNIT

(Sonar control unit)
— Diagnosis condition When ignition switch is ON
Signal (terminal) —
Threshold Sonar ECU internal failure (under voltage)
Diagnosis delay time —
B2724–24 Diagnosis condition When ignition switch is ON
Signal (terminal) —
Threshold Sonar ECU internal failure (over voltage)
Diagnosis delay time —
B2724–44 Diagnosis condition When ignition switch is ON
Signal (terminal) —
Threshold Sonar ECU internal failure (RAM failure)
Diagnosis delay time —
B2724–45 Diagnosis condition When ignition switch is ON
Signal (terminal) —
Threshold Sonar ECU internal failure (ROM failure)
Diagnosis delay time —
B2724–46 Diagnosis condition When ignition switch is ON
Signal (terminal) —
Threshold Sonar ECU internal failure (EEPROM failure)
Diagnosis delay time —
B2724–48 Diagnosis condition When ignition switch is ON
Signal (terminal) —
Threshold Sonar ECU internal failure (internal software execution failure)
Diagnosis delay time —
B2724–49 Diagnosis condition When ignition switch is ON
Signal (terminal) —
Threshold Sonar ECU internal failure (basic chip set failure)
Diagnosis delay time —
B2724–55 Diagnosis condition When ignition switch is ON
Signal (terminal) —
Threshold Sonar ECU internal failure (not configured)
Diagnosis delay time —
B2724–86 Diagnosis condition When ignition switch is ON
Signal (terminal) —
Threshold Sonar ECU internal failure (SPI comm failure)
Diagnosis delay time —
B2724–87 Diagnosis condition When ignition switch is ON
Signal (terminal) —
Threshold Sonar ECU internal failure (high side switch failure)
Diagnosis delay time —

POSSIBLE CAUSE

  • Charging system malfunction

  • Sonar control unit power supply or ground circuit

  • Sonar control unit configuration

  • Sonar control unit

FAIL-SAFE

  • Off indicator blinks periodically (500ms ON, 500ms OFF).

  • Sonar buzzer sounds for 3 seconds.

Confirmation Procedure

DTC CONFIRMATION PROCEDURE

CONSULT

  1. Ignition switch ON.

  2. Select “Self Diagnostic Result” mode of “SONAR”.

Is DTC B2724–23, 24, 44, 45, 46, 48, 49, 55, 86, 87 detected?

YES>>

Refer to DTC Diagnosis Procedure.

NO>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO>>

Confirmation after repair: Inspection End.

DTC Diagnosis Procedure

DETERMINE MALFUNCTION TYPE

CONSULT

  1. Ignition switch ON.

  2. Select “Self Diagnostic Result” mode of “SONAR”.

  3. Check DTC.

Is DTC B2724–23, 24, 44, 45, 46, 48, 49, 55, 86 or 87 detected?

YES>>

23 or 24 – GO TO 2.

YES>>

55 – GO TO 4.

YES>>

44, 45, 46, 48, 49, 86 or 87 – GO TO 5.

NO>>

Refer to Intermittent Incident.

CHECK CHARGING SYSTEM

Check the Nissan Murano vehicle charging system. Refer to Work Flow (With 165-DSS-5000P) or Work Flow (Without 165-DSS-5000P).

Is the inspection result normal?

YES>>

GO TO 3.

NO>>

Repair or replace the malfunctioning components.

CHECK SONAR CONTROL UNIT POWER SUPPLY AND GROUND

Perform the sonar control unit power supply and ground circuit diagnosis procedure. Refer to Diagnosis Procedure.

Is the inspection result normal?

YES>>

Replace sonar control unit. Refer to Removal and Installation.

NO>>

Repair or replace harness or connectors.

PERFORM SONAR CONTROL UNIT CONFIGURATION PROCEDURE

CONSULT

Perform the sonar control unit configuration procedure. Refer to Work Procedure.

Was the configuration procedure successful?

YES>>

GO TO 5.

NO>>

Replace sonar control unit. Refer to Removal and Installation.

PERFORM DTC CONFIRMATION PROCEDURE AGAIN

CONSULT

  1. Ignition switch ON.

  2. Erase DTC.

  3. Select “Self Diagnostic Result” mode of “SONAR”.

  4. Check DTC.

Is DTC B2724–44, 45, 46, 48, 49, 55, 86 or 87 detected?

YES>>

Replace sonar control unit. Refer to Removal and Installation.

NO>>

Inspection End.