Driver Information & Multimedia
Power Supply and Ground Circuit
In this manual: Driver Information & Multimedia
5steps
~30min
2/5difficulty
Done 0 of 5
CHECK FUSE
Check that the following fuse is not blown:
| Terminal No. | Signal name | Fuse No. | Capacity |
|---|---|---|---|
| 12 | IGN power supply | 29 | 10 A |
Is the fuse blown?
YES>>Replace the blown fuse after repairing the affected circuit.
NO>>GO TO 2.
CHECK POWER SUPPLY CIRCUIT
Ignition switch OFF.
Disconnect sonar control unit connector.
Check voltage between sonar control unit connector and ground.
Sonar control unit — Condition Voltage
(Approx.)Connector Terminal M70 12 Ground Ignition switch: ON Battery voltage
Is the inspection result normal?
YES>>GO TO 3.
NO>>Repair or replace harness or connectors.
CHECK GROUND CIRCUIT
Ignition switch OFF.
Check continuity between sonar control unit connector and ground.
Sonar control unit — Continuity Connector Terminal M70 15 Ground Yes
Is the inspection result normal?
YES>>Inspection End.
NO>>Repair or replace harness or connectors.
Was this page helpful?