Driver Information & Multimedia

B272d Front Buzzer

13steps
~78min
3/5difficulty
Done 0 of 13
DTC Description

DTC DETECTION LOGIC

DTC No.

CONSULT screen terms

(Trouble diagnosis content)

DTC detection condition
B272D–12

FRONT BUZZER

(Sonar buzzer)
— Diagnosis condition When ignition switch is ON
Signal (terminal)
  • Sonar buzzer power circuit (terminal 19)

  • Sonar buzzer signal (terminal 18)

Threshold
  • Sonar buzzer power circuit is short to voltage

  • Sonar buzzer signal circuit is short to voltage

Diagnosis delay time —
B272D–14 Diagnosis condition When ignition switch is ON
Signal (terminal)
  • Sonar buzzer power circuit (terminal 19)

  • Sonar buzzer signal (terminal 18)

Threshold
  • Sonar buzzer power circuit is open or short to ground

  • Sonar buzzer signal circuit is open or short to ground

Diagnosis delay time —

POSSIBLE CAUSE

  • Harness or connectors

  • Sonar buzzer

FAIL-SAFE

  • Off indicator blinks periodically (500ms ON, 500ms OFF).

  • Audible warning (sonar buzzer) of all sensors is stopped.

DTC Confirmation Procedure

DTC CONFIRMATION PROCEDURE

CONSULT

  1. Ignition switch ON.

  2. Select “Self Diagnostic Result” mode of “SONAR”.

Is DTC B272D–12, 14 detected?

YES>>

Refer to DTC Diagnosis Procedure.

NO>>

To check malfunction symptom before repair: Refer to Intermittent Incident.

NO>>

Confirmation after repair: Inspection End.

Diagnosis Procedure

DETERMINE MALFUNCTION TYPE

CONSULT

  1. Ignition switch ON.

  2. Select “Self Diagnostic Result” mode of “SONAR”.

  3. Check DTC.

Is DTC B272D–12 or 14 detected?

YES>>

12 – GO TO 2.

YES>>

14 – GO TO 3.

NO>>

Refer to Intermittent Incident.

CHECK SONAR BUZZER CIRCUIT SHORT TO BATTERY

  1. Ignition switch OFF.

  2. Disconnect sonar control unit connector.

  3. Ignition switch ON.

  4. Check voltage between sonar control unit connector and ground.

    Sonar control unit —

    Voltage

    (Approx.)
    Connector Terminal
    M70 19 Ground 0 V
    18

Is the inspection result normal?

YES>>

Replace sonar buzzer. Refer to Removal and Installation.

NO>>

Repair or replace harness or connectors.

CHECK SONAR BUZZER CIRCUIT OPEN OR SHORT TO GROUND

  1. Ignition switch OFF.

  2. Disconnect sonar control unit and sonar buzzer connectors.

  3. Check continuity between sonar control unit connector and sonar buzzer connector.

    Sonar control unit Sonar buzzer Continuity
    Connector Terminal Connector Terminal
    M70 19 M140 2 Yes
    18 3
  4. Check continuity between sonar control unit connector and ground.

    Sonar control unit — Continuity
    Connector Terminal
    M70 19 Ground No
    18

Is the inspection result normal?

YES>>

Replace sonar buzzer. Removal and Installation.

NO>>

Inspection End.