Body Exterior, Doors, Roof & Vehicle Security
Body Construction
In this manual: Body Exterior, Doors, Roof & Vehicle Security
~1min read

| 1. | Body side outer | 2. | Front pillar inner upper | 3. | Upper front pillar reinforcement |
| 4. | Dash side inner | 5. | Front hinge pillar lower reinforcement | 6. | Outer sill reinforcement |
| 7. | Inner sill | 8. | Center pillar reinforcement | 9. | Inner center pillar |
| 10. | Rear sill assembly | 11. | Rear wheel housing assembly | 12. | Back pillar inner reinforcement |
| 13. | Roof rail brace assembly | 14. | Back pillar inner | 15. | Back pillar seat belt reinforcement |
Apply the fusible insulator to prevent road noise, vibration and exhaust system heat inside the vehicle.
The service replacement material is cut-to-fit and not supplied in the same shape as original factory installed fusible insulator.
Place the fusible insulators in the positions shown in the figure and properly affix them to the vehicle surface.

Unit: mm (in)
| : Nissan Murano Vehicle front | |
| : Fusible insulator thickness 3.5 (0.138) |

Unit: mm (in)
| : Nissan Murano Vehicle front | |
| : Fusible insulator thickness 3.5 (0.138) |
Was this page helpful?