Steering

C1143 St Ang Sen Circuit

2steps
~12min
1/5difficulty
Done 0 of 2
DTC Description

DTC DETECTION LOGIC

DTC No.CONSULT screen terms (Trouble diagnosis content)DTC detection condition
C1143

ST ANG SEN CIRCUIT

(Steering angle sensor circuit)
Diagnosis condition When ignition switch ON.
Signal (terminal) Steering angle sensor signal
Threshold Steering angle sensor signal failure
Diagnosis delay time 2 seconds or more

POSSIBLE CAUSE

  • Harness or connectors

  • Steering angle sensor

  • Power steering control module

FAIL-SAFE

Certain steering assist force

DTC Confirmation Procedure

PRECONDITIONING

If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always place the ignition switch in the OFF position and wait at least 10 seconds before conducting the next test.

>>

GO TO 2.

DTC REPRODUCTION PROCEDURE

CONSULT

  1. Ignition switch OFF to ON.

  2. Select "Self Diagnostic Result" mode of "EPS/DAST 3".

Is DTC “C1143” detected?

YES>>

Proceed to diagnosis procedure. Refer to DTC Diagnosis Procedure.

NO>>

Inspection End.

DTC Diagnosis Procedure

CHECK STEERING ANGLE SENSOR CIRCUIT

Check steering angle sensor circuit. Refer to Diagnosis Procedure.

Is the inspection result normal?

YES>>

GO TO 2.

NO>>

Repair or replace malfunctioning component.

CHECK TERMINALS AND HARNESS CONNECTORS

Check the power steering control module pin terminals for damage or loose connection with harness connector.

Is the inspection result normal?

YES>>

Power steering control module is malfunctioning. Replace power steering oil pump assembly. Refer to Removal and Installation.

NO>>

Repair or replace malfunctioning component.