Steering
C160a Heat Protection
In this manual: Steering
2steps
~12min
1/5difficulty
Done 0 of 2
DTC DETECTION LOGIC
| DTC No. | CONSULT screen terms (Trouble diagnosis content) | DTC detection condition | |
|---|---|---|---|
| C160A | HEAT PROTECTION (Heat protection) |
Diagnosis condition | When engine is running. |
| Signal (terminal) | — | ||
| Threshold | When the steering wheel is operated excessively and the interior temperature of the power steering system reaches 244.4°F (118°C) or more (Protection function) | ||
| Diagnosis delay time | 2 seconds or more | ||
POSSIBLE CAUSE
The protection of the hydraulic pump electric power steering system
FAIL-SAFE
—
PRECONDITIONING
If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always place the ignition switch in the OFF position and wait at least 10 seconds before conducting the next test.
>>GO TO 2.
DTC REPRODUCTION PROCEDURE
CONSULT
Ignition switch OFF to ON.
Select "Self Diagnostic Result" mode of "EPS/DAST 3".
Is DTC “C160A” detected?
YES>>Go to Work Flow.
NO>>Inspection End.
Was this page helpful?