Steering

C1606 Eps Motor

7steps
~42min
2/5difficulty
Done 0 of 7
DTC Description

DTC DETECTION LOGIC

DTC No.CONSULT screen terms (Trouble diagnosis content)DTC detection condition
C1606

EPS MOTOR

(EPS motor)
Diagnosis condition When engine is running.
Signal (terminal) —
Threshold Power steering motor failure or power steering control module motor driver failure
Diagnosis delay time 1 second or more

POSSIBLE CAUSE

  • Harness or connectors

  • Power steering control motor

  • Power steering control module

FAIL-SAFE

Manual steering state

DTC Confirmation Procedure

PRECONDITIONING

If “DTC CONFIRMATION PROCEDURE” has been previously conducted, always place the ignition switch in the OFF position and wait at least 10 seconds before conducting the next test.

>>

GO TO 2.

DTC REPRODUCTION PROCEDURE

CONSULT

  1. Ignition switch OFF to ON.

  2. Select "Self Diagnostic Result" mode of "EPS/DAST 3".

Is DTC “C1606” detected?

YES>>

Proceed to diagnosis procedure. Refer to DTC Diagnosis Procedure.

NO>>

Inspection End.

DTC Diagnosis Procedure

SELF DIAGNOSTIC RESULT

CONSULT

  1. Ignition switch OFF to ON.

  2. Erase "Self Diagnostic Result" mode of "EPS/DAST 3".

  3. Ignition switch OFF and wait for at least 10 seconds.

  4. Ignition switch ON.

  5. Select "Self Diagnostic Result" mode of "EPS/DAST 3".

Is DTC “C1606” detected?

YES>>

Power steering motor is malfunctioning. Replace power steering oil pump assembly. Refer to Removal and Installation.

NO>>

Check pin terminal and connection of each harness connector for malfunctioning conditions.