Steering

Hydraulic Pump Electric Power Steering Warning Lamp

7steps
~42min
3/5difficulty
Done 0 of 7
Component Function Check

CHECK THE ILLUMINATION OF THE HYDRAULIC PUMP ELECTRIC POWER STEERING WARNING LAMP

Check that the hydraulic pump electric power steering warning lamp turns ON when ignition switch ON. Then, hydraulic pump electric power steering warning lamp turns OFF after the engine is started.

Is the inspection result normal?

YES>>

Inspection End.

NO>>

Perform trouble diagnosis. Refer to Diagnosis Procedure.

Diagnosis Procedure

SELF DIAGNOSTIC RESULT

CONSULT

  1. Ignition switch OFF to ON.

  2. Select "Self Diagnostic Result" mode of "EPS/DAST 3".

Is any DTC detected?

YES>>

Check the DTC. Refer to DTC Index.

NO>>

GO TO 2.

CHECK HYDRAULIC PUMP ELECTRIC POWER STEERING WARNING LAMP SIGNAL

CONSULT

  1. Ignition switch ON.

  2. Select "WARNING LAMP" in "Data Monitor" mode of "EPS/DAST 3".

  3. Check that the item in “Data Monitor” mode is “On”.

  4. Start the engine.

  5. Check that the item in “Data Monitor” mode is “Off”.

Is the inspection result normal?

YES>>

Perform the trouble diagnosis for combination meter power supply circuit. Refer to Diagnosis Procedure.

NO>>

GO TO 3.

CHECK TERMINALS AND HARNESS CONNECTORS

Check the power steering control module pin terminals for damage or loose connection with harness connector.

Is the inspection result normal?

YES>>

Power steering control module is malfunctioning. Replace power steering oil pump assembly. Refer to Removal and Installation.

NO>>

Repair or replace the malfunctioning component.