Suspension

C1734 Control Unit

7steps
~42min
2/5difficulty
Done 0 of 7
DTC Description
  • Activate and display TPMS sensor IDs

  • Display tire pressure reported by the TPMS sensor

  • Read TPMS DTCs

  • Register TPMS sensor IDs

DTC DETECTION LOGIC

DTC No.

CONSULT screen terms

(Trouble diagnosis content)
DTC detection condition
C1734

CONTROL UNIT

(Control unit)
Diagnosis condition When ignition switch ON.
Signal (terminal) —
Threshold TPMS malfunction in BCM.
Diagnosis delay time —

POSSIBLE CAUSE

BCM

FAIL-SAFE

—

DTC Confirmation Procedure

PERFORM SELF DIAGNOSTIC RESULT

CONSULT

  1. Ignition switch ON.

  2. Select “Self Diagnostic Result” mode of "BCM(AIR PRESSURE MONITOR)".

  3. Check DTC.

Is DTC C1734 detected?

YES>>

Refer to DTC Diagnosis Procedure.

NO>>

Inspection End.

DTC Diagnosis Procedure
  • Activate and display TPMS sensor IDs

  • Display tire pressure reported by the TPMS sensor

  • Read TPMS DTCs

  • Register TPMS sensor IDs

CHECK BCM HARNESS CONNECTORS

Check BCM harness connectors for damage or loose connections.

Is the inspection result normal?

YES>>

GO TO 2.

NO>>

Repair or replace connectors.

CHECK BCM POWER SUPPLY AND GROUND

Check BCM power supply and ground. Refer to Diagnosis Procedure.

Is the inspection result normal?

YES>>

GO TO 3.

NO>>

Repair or replace harness or connectors.

CHECK REMOTE KEYLESS ENTRY RECEIVER POWER CIRCUIT

Check voltage between remote keyless entry receiver harness connector and ground.

(+)(—)

Voltage

(Approx.)
Remote keyless entry receiver
ConnectorTerminal
M86 1 Ground Battery voltage

Is the inspection result normal?

YES>>

GO TO 4.

NO>>

Repair or replace harness or connectors.

CHECK REMOTE KEYLESS ENTRY RECEIVER SIGNAL CIRCUIT

  1. Ignition switch OFF.

  2. Disconnect BCM connector and remote keyless entry receiver connector.

  3. Check continuity between BCM harness connector and remote keyless entry receiver harness connector.

    BCMRemote keyless entry receiverContinuity
    ConnectorTerminalConnectorTerminal
    M80 119 M86 2 Yes
  4. Check continuity between BCM harness connector and ground.

    BCM—Continuity
    ConnectorTerminal
    M80 119 Ground No

Is the inspection result normal?

YES>>

GO TO 5.

NO>>

Repair or replace harness or connectors.

CHECK REMOTE KEYLESS ENTRY RECEIVER GROUND CIRCUIT

Check continuity between remote keyless entry receiver harness connector and ground.

Remote keyless entry receiver—Continuity
ConnectorTerminal
M86 3 Ground Yes

Is the inspection result normal?

YES>>

GO TO 6.

NO>>

Repair or replace harness or connectors.

CHECK BCM INPUT/OUTPUT SIGNALS

Check BCM input/output signals. Refer to Reference Value.

Is the inspection result normal?

YES>>

Inspection End.

NO>>

Replace BCM. Refer to Removal and Installation.