Suspension

Low Tire Pressure Warning Lamp

3steps
~18min
2/5difficulty
Done 0 of 3
Component Function Check

CHECK THE ILLUMINATION OF THE LOW TIRE PRESSURE WARNING LAMP

Check that the low tire pressure warning lamp is turned OFF after illuminating for approximately 1 second, when the ignition switch is placed ON.

Is the inspection result normal?

YES>>

Inspection End.

NO>>

Perform trouble diagnosis. Refer to Diagnosis Procedure.

Diagnosis Procedure

BCM POWER SUPPLY AND GROUND CIRCUIT

Check BCM power supply and ground circuit. Refer to Diagnosis Procedure.

Is the inspection result normal?

YES>>

GO TO 2.

NO>>

Repair or replace malfunctioning components.

PERFORM SELF DIAGNOSTIC RESULT

CONSULT

Select “Self Diagnostic Result” mode of "BCM(AIR PRESSURE MONITOR)".

Is any DTC detected?

YES>>

Check the DTC. Refer to DTC Index.

NO>>

GO TO 3.

CHECK LOW TIRE PRESSURE WARNING LAMP SIGNAL

CONSULT

  1. Ignition switch ON.

  2. Select “Data Monitor” mode of "BCM(AIR PRESSURE MONITOR)".

  3. Select “WARNING LAMP” in “Data Monitor”, and check that the low tire pressure warning lamp is turned OFF after illuminating for approximately 1 second, when the ignition switch ON.

Is the inspection result normal?

YES>>

Check the combination meter. Refer to Diagnosis Procedure.

NO>>

Replace the BCM. Refer to Removal and Installation.