Suspension

C1735 Ign Circuit Open

5steps
~30min
2/5difficulty
Done 0 of 5
DTC Description
  • Activate and display TPMS sensor IDs

  • Display tire pressure reported by the TPMS sensor

  • Read TPMS DTCs

  • Register TPMS sensor IDs

DTC DETECTION LOGIC

DTC No.

CONSULT screen terms

(Trouble diagnosis content)
DTC detection condition
C1735

IGN CIRCUIT OPEN

(Ignition circuit open)
Diagnosis condition When ignition switch ON.
Signal (terminal) —
Threshold BCM has detected a mismatch between IGN ON signals.
Diagnosis delay time —

POSSIBLE CAUSE

BCM

FAIL-SAFE

—

DTC Confirmation Procedure

PERFORM SELF DIAGNOSTIC RESULT

CONSULT

  1. Ignition switch ON.

  2. Select “Self Diagnostic Result” mode of "BCM(AIR PRESSURE MONITOR)".

  3. Check DTC.

Is DTC C1735 detected?

YES>>

Refer to DTC Diagnosis Procedure.

NO>>

Inspection End.

DTC Diagnosis Procedure
  • Activate and display TPMS sensor IDs

  • Display tire pressure reported by the TPMS sensor

  • Read TPMS DTCs

  • Register TPMS sensor IDs

CHECK CAN IGNITION SIGNAL

CONSULT

  1. Select “IGN RLY1-F/B” in “Data Monitor” mode of "BCM(INTELLIGENT KEY)".

  2. Check that the function operates normally according to the following conditions:

    Monitor itemDisplayed value
    IGN RLY1 F/B On with ignition in ON position

Is the inspection result normal?

YES>>

GO TO 2.

NO>>

Check CAN system. Refer to Trouble Diagnosis Flow Chart.

CHECK BCM POWER SUPPLY AND GROUND

Check BCM power supply and ground. Refer to Diagnosis Procedure.

Is the inspection result normal?

YES>>

GO TO 3.

NO>>

Repair or replace harness or connectors.

DRIVE Nissan Murano Vehicle

CONSULT

Clear DTC and test drive vehicle to check for low tire pressure warning lamp.

Does the Nissan Murano vehicle operate without any low tire pressure warning lamp?

YES>>

Inspection End.

NO>>

Replace BCM. Refer to Removal and Installation.