Suspension

C1769 Config Setting

3steps
~18min
2/5difficulty
Done 0 of 3
DTC Description
  • Activate and display TPMS sensor IDs

  • Display tire pressure reported by the TPMS sensor

  • Read TPMS DTCs

  • Register TPMS sensor IDs

DTC DETECTION LOGIC

DTC No.

CONSULT screen terms

(Trouble diagnosis content)
DTC detection condition
C1769

CONFIG SETTING

(Configuration setting)
Diagnosis condition When ignition switch ON.
Signal (terminal) —
Threshold
  • Tire pressure monitoring system configuration has not been performed.

  • Receiver ID registration cannot be performed.

Diagnosis delay time —

POSSIBLE CAUSE

  • Configuration is not completed.

  • The ID registration is not completed.

FAIL-SAFE

—

DTC Confirmation Procedure

PERFORM SELF DIAGNOSTIC RESULT

CONSULT

  1. Ignition switch ON.

  2. Select “Self Diagnostic Result” mode of "BCM(AIR PRESSURE MONITOR)".

  3. Check DTC.

Is DTC “C1769” detected?

YES>>

Refer to DTC Diagnosis Procedure.

NO>>

Prior to repair: Refer to Intermittent Incident.

NO>>

Confirmation after repair: Inspection End.

DTC Diagnosis Procedure
  • Activate and display TPMS sensor IDs

  • Display tire pressure reported by the TPMS sensor

  • Read TPMS DTCs

  • Register TPMS sensor IDs

BCM CONFIGURATION

Perform configuration. Refer to Work Procedure.

>>

GO TO 2.

TIRE PRESSURE SENSOR ID REGISTRATION

Perform tire pressure sensor ID registration. Refer to Work Procedure.

Does low tire pressure warning lamp turn OFF?

YES>>

Inspection End.

NO>>

Perform configuration tire pressure monitoring system again. Refer to Work Procedure.