Cruise Control & Driver Assistance

C1a16 Radar Blocked or Stained

9steps
~54min
2/5difficulty
Done 0 of 9
DTC Description

DTC DETECTION LOGIC

DTC No.CONSULT screen termsDTC detection condition
C1A16–97 RADAR BLOCKED Diagnosis condition When ignition switch is ON.
Signal (terminal) —
Threshold If any stain occurs to distance sensor body window.
Diagnosis delay time —
  • When contamination or foreign materials adhere to the distance sensor (ICC sensor) area.

  • When driving while it is snowing or when frost forms on the distance sensor (ICC sensor) area.

  • When distance sensor (ICC sensor) area is temporarily fogged.

POSSIBLE CAUSE

  • Stain or foreign material deposited on distance sensor (ICC sensor)

  • Cracked or scratched distance sensor (ICC sensor)

FAIL-SAFE

  • Intelligent Cruise Control system is canceled

  • Automatic Emergency Braking (AEB) is canceled.

Diagnosis Procedure

VISUAL CHECK 1

Check for contamination and foreign matter on the distance sensor (ICC sensor) area of the front bumper.

Does contamination or foreign material exist?

YES>>

Clean the contamination and foreign material on the distance sensor (ICC sensor) area of the front bumper.

NO>>

GO TO 2.

VISUAL CHECK 2

Check distance sensor (ICC sensor) for contamination and foreign materials.

Does contamination or foreign material exist?

YES>>

Clean the contamination and foreign material from the distance sensor (ICC sensor).

NO>>

GO TO 3.

VISUAL CHECK 3

Check distance sensor (ICC sensor) and distance sensor (ICC sensor) bracket for damage or looseness.

Does damage or looseness exist?

YES>>
  1. Repair or replace effected components. Refer to Removal and Installation.

  2. Perform distance sensor (ICC sensor) alignment. Refer to Work Procedure.

  3. Perform action test. Refer to Description.

NO>>

GO TO 4.

INTERVIEW

  1. Ask if there is any trace of contamination or foreign materials adhering to the distance sensor (ICC sensor) area.

  2. Ask if the distance sensor (ICC sensor) area was frosted during driving or if Nissan Murano vehicle was driven in snow.

  3. Ask if distance sensor (ICC sensor) area was temporarily fogged. (Windshield glass may also tend to fog, etc.)

Are any of the above conditions seen?

YES>>

Explain to the customer about the difference between the contamination detection function and an actual malfunction. Inform them “this is not a malfunction”.

NO>>
  1. Perform distance sensor (ICC sensor) alignment. Refer to Work Procedure.

  2. Perform action test. Refer to Description.

  3. GO TO 5.

CHECK DISTANCE SENSOR (ICC SENSOR) SELF DIAGNOSTIC RESULTS

CONSULT

Check if “C1A16–97” is detected as the current malfunction in “Self Diagnostic Result” mode of “LASER/RADAR”.

Is “C1A16–97” detected?

YES>>

Replace distance sensor (ICC sensor). Refer to Removal and Installation.

NO>>

Inspection End