Driver Controls
Front Room/map Lamp Assembly
In this manual: Driver Controls
~1min read

| 1. | Headlining | 2. | Front room/map lamp assembly bracket (without panoramic roof glass) | 3. | Front room/map lamp assembly bracket (with panoramic roof glass) |
| 4. | Panoramic roof switch finisher | 5. | Front room/map lamp assembly | 6. | Map lamp |
| Pawl | Clip | Metal Clip | |||
| Front |
REMOVAL
Lower front edge of map lamp assembly (1) down from headlining by releasing metals clips, then slide forward to clear pawls at rear.

: Metal clip
: Pawl
Disconnect the harness connectors from the map lamp assembly and remove.
INSTALLATION
Installation is in the reverse order of removal.
REMOVAL
Remove map lamp assembly. Refer to Removal and Installation.
Remove screws (A) from map lamp (2).

Release pawls and remove map lamp from map lamp assembly (1).
: Pawl
INSTALLATION
Installation is in the reverse order of removal.
Was this page helpful?