Engine
Fuel Pump Control Module (fpcm)
In this manual: Engine
~1min read
SYSTEM DIAGRAM

*1: ECM determines the start signal status by the signals of engine speed and battery voltage.
*2: This sensor is not used to control the engine system under normal conditions.
INPUT/OUTPUT SIGNAL CHART
| Sensor | Input signal to ECM | ECM function | Actuator |
|---|---|---|---|
| Crankshaft position sensor (POS) | Engine speed* | Fuel pump control | FPCM ↓ Fuel pump |
| Camshaft position sensor (PHASE) | |||
| Engine coolant temperature sensor | Engine coolant temperature | ||
| Mass air flow sensor | Amount of intake air | ||
| Battery | Battery voltage* |
*: ECM determines the start signal status by the signals of engine speed and battery voltage.
SYSTEM DESCRIPTION
The fuel pump control module (FPCM) controls the discharging volume of the fuel pump by the FPCM control signals (Low/Mid/High) depending on driving conditions.
| Conditions | Amount of fuel flow | Supplied voltage |
|---|---|---|
| For 1 second after turning ignition switch ON | Low | Approximately 8.5 V |
|
High | Battery voltage 12 V |
| Except the above | Mid | Approximately 10 V |
Was this page helpful?