Body Exterior, Doors, Roof & Vehicle Security
Moonroof Motor Assembly
In this manual: Body Exterior, Doors, Roof & Vehicle Security
~1min read

| 1. | Panoramic roof glass | 2. | Moonroof drain | 3. | Wind deflector |
| 4. | Glass lid | 5. | Side trim covers (LH/RH) | 6. | Front drain hose (LH/RH) |
| 7. | Moonroof motor assembly | 8. | Sunshade motor assembly | 9. | Moonroof front bracket (LH/RH) |
| 10. | Moonroof rear bracket (LH/RH) | 11. | Rear drain hose (LH/RH) | 12. | Moonroof unit assembly |
| 13. | Rear trim covers (LH/RH) | 14. | Sunshade | Front | |
| Pawl | Clip |
REMOVAL
Close glass lid.
Remove the headlining. Refer to Removal and Installation.
Disconnect harness connector (A) from moonroof motor assembly (1).

Remove moonroof motor assembly screws (B) and release from moonroof unit assembly (2)
: Front
INSTALLATION
Move moonroof motor assembly laterally little by little so that the gear is completely engaged into the wire on the moonroof unit assembly, and the mounting surfaces become parallel. Install the moonroof motor assembly screws and tighten.
Remainder of installation is in the reverse order of removal.
Was this page helpful?