Driver Information & Multimedia
Power Supply and Ground Circuit. Audio Unit
In this manual: Driver Information & Multimedia
5steps
~30min
2/5difficulty
Done 0 of 5
CHECK FUSE
Check that the following fuses are not blown:
| Terminal No. | Signal name | Fuse No. | Capacity |
|---|---|---|---|
| 7 | ACC power supply | 7 | 10 A |
| 17 | Ignition power supply | 29 | 10 A |
| 19 | Battery power supply | 15 | 20 A |
Are the fuses blown?
YES>>Replace the blown fuse after repairing the affected circuit.
NO>>GO TO 2.
CHECK POWER SUPPLY CIRCUIT
Ignition switch OFF.
Disconnect audio unit connector.
Check voltage between audio unit connector and ground.
Audio unit Ground Condition Voltage
(Approx.)Connector Terminal M121 7 — Ignition switch: ON Battery voltage 17 19 Ignition switch: OFF
Is the inspection result normal?
YES>>GO TO 3.
NO>>Repair or replace harness or connectors.
CHECK GROUND CIRCUIT
Ignition switch OFF.
Check continuity between audio unit connector and ground.
Audio unit Ground Continuity Connector Terminal M121 20 — Yes
Is the inspection result normal?
YES>>Inspection End.
NO>>Repair or replace harness or connectors.
Was this page helpful?