Cruise Control & Driver Assistance
Power Supply and Ground Circuit (lane Camera Unit)
In this manual: Cruise Control & Driver Assistance
3steps
~18min
2/5difficulty
Done 0 of 3
CHECK FUSES
Check that the following fuse is not blown.
| Signal name | Fuse No. |
|---|---|
| Ignition power supply | 29(10A) |
Is the fuse blown?
YES>>Replace the blown fuse after repairing the affected circuit.
NO>>GO TO 2.
CHECK LANE CAMERA UNIT POWER SUPPLY CIRCUIT
Check voltage between lane camera unit harness connector and ground.
| Terminal | Condition | Voltage (Approx.) |
||
| (+) | (–) | |||
| Lane camera unit | Ground | Ignition switch | ||
| Connector | Terminal | |||
| R23 | 3 | OFF | 0 V | |
| ON | Battery voltage | |||
Is the inspection result normal?
YES>>GO TO 3.
NO>>Repair the lane camera unit power supply circuit.
CHECK LANE CAMERA UNIT GROUND CIRCUIT
Turn the ignition switch OFF.
Disconnect the lane camera unit connector.
Check for continuity between lane camera unit harness connector and ground.
Lane camera unit Ground Continuity Connector Terminal R23 1 Yes
Is the inspection result normal?
YES>>Inspection End.
NO>>Repair the lane camera unit ground circuit.
Was this page helpful?