Cruise Control & Driver Assistance
Power Supply and Ground Circuit (side Radar Lh)
In this manual: Cruise Control & Driver Assistance
3steps
~18min
2/5difficulty
Done 0 of 3
CHECK FUSES
Check that the following fuse is not blown:
| Signal name | Fuse No. |
|---|---|
| Ignition power supply | 29(10 A) |
Is the fuse blown?
YES>>Replace the blown fuse after repairing the affected circuit.
NO>>GO TO 2.
CHECK POWER SUPPLY CIRCUIT
Turn ignition switch OFF.
Disconnect the side radar LH connector.
Check voltage between side radar LH harness connector and ground.
| Terminal | Condition | Voltage (Approx.) |
||
| (+) | (−) | |||
| Side radar LH | Ground | Ignition switch | ||
| Connector | Terminal | |||
| B465 | 5 | OFF | 0 V | |
| ON | Battery voltage | |||
Is the inspection result normal?
YES>>GO TO 3.
NO>>Repair the side radar LH power supply circuit.
CHECK GROUND CIRCUIT
Check continuity between side radar LH harness connector and ground.
| Side radar LH | Ground | Continuity | |
| Connector | Terminal | ||
| B465 | 8 | Yes | |
Is the inspection result normal?
YES>>Inspection End.
NO>>Repair the side radar LH ground circuit.
Was this page helpful?