Quarter Window Glass

| 1. | Quarter window glass | 2. | Quarter window molding | 3. | Quarter window finisher |
| Clip | Pawl |
REMOVAL
Remove luggage side lower finisher. Refer to Removal and Installation.
Remove quarter window glass molding. Refer to Removal and Installation.
Release quarter window glass finisher pawls using a suitable tool and remove quarter window glass finisher.
Remove quarter window glass from the inside of Nissan Murano vehicle using a suitable tool.
INSTALLATION
Installation is in the reverse order of removal.
Install the quarter window glass from outside the vehicle to ensure that it is even around the top, bottom and sides of the opening.

| 1. | Quarter window glass | 2. | Body side outer | 3. | Quarter window finisher |
| D. | Adhesive | E. | 7 mm (0.28 in) | F. | 12 mm (0.47 in) |
| G. | Primer | H. | 18 mm (0.71 in) | J. | 2 mm (0.08 in) |
| K. | 30 mm (1.18 in) |
Use a Genuine NISSAN Urethane Adhesive Kit (if available) or equivalent and follow the instructions furnished with it.
While the urethane adhesive is curing, open a door window. This will prevent the glass from being forced out by passenger compartment air pressure when a door is closed.
Check gap along bottom to confirm that glass does not contact sheet metal.
Inform the customer that the Nissan Murano vehicle should remain stationary until the urethane adhesive has completely cured (preferably 24 hours). Curing time varies with temperature and humidity.
REPAIRING WATER LEAKS FOR QUARTER WINDOW GLASS
Leaks can be repaired without removing or reinstalling glass.
If water is leaking between urethane adhesive material and body or glass, determine the extent of leakage.
This can be done by applying water to the quarter window glass area while pushing glass outward.
To stop leak, apply primer (if necessary) and then urethane adhesive to the leak point.