Rear Door Glass

| 1. | Rear door | 2. | Rear door glass rubber run | 3. | Rear door glass rear run |
| 4. | Rear door glass corner finisher | 5. | Rear door glass | 6. | Rear door glass power window motor |
| 7. | Rear door glass regulator |
REMOVAL
Remove rear door finisher. Refer to Removal and Installation.
Remove rear door vapor barrier (1).

Temporarily reconnect the rear power window switch.
Operate rear power window switch to raise/lower rear door glass until rear door regulator to glass bolts (A) can be seen and remove.

Partially remove rear door glass rubber run channel.
Remove screws and rear door corner finisher (1).

Remove rear door regulator to glass bolts and rear door glass (1).

INSTALLATION
Installation is in the reverse order of removal.
Fitting Inspection
Check that the rear door glass is securely fit into the rear door glass run channel.
Lower the rear door glass slightly [approximately 10 to 20 mm (0.4 to 0.8 in)], and check that the clearance to the sash is parallel. If the clearance between the rear door glass and sash is not parallel, loosen the rear door regulator to glass bolts, guide rail bolts, and rear door glass and carrier plate bolts to correct the rear door glass position.