Suspension

Rear Lower Link Coil Spring

~2min read
Exploded View
1. Upper seat 2. Rear suspension member 3. Coil spring
4. Lower rubber seat 5. Rear lower link 6. Rear knuckle
Front
Removal and Installation

REMOVAL

Remove the front undercover. Refer to Removal and Installation.

Support the front of vehicle with a suitable jack.

Remove the rear wheel and tire using power tool. Refer to Removal and Installation.

Put alignment marks on the adjusting bolt and on the rear lower link.

Loosen the rear lower link adjusting bolt on the rear suspension member.

Support the rear lower link with a suitable jack.

Support the rear knuckle with a suitable jack.

Remove the rear lower link nut and bolt from the rear knuckle using power tool.

Slowly lower the suitable jack supporting the rear lower link. Remove the upper seat, the coil spring, and the lower rubber seat from the rear lower link.

Remove the rear lower link nut and bolt from the rear suspension member using power tool.

Remove the rear lower link.

INSTALLATION

Installation is in the reverse order of removal.

  • Make sure that the upper seat is attached as shown.

    : Body
  • Perform the final tightening of the parts under unladen conditions with the tires on level ground.

  • Check the wheel alignment. Refer to Inspection.

  • Adjust the neutral position of the steering angle sensor. Refer to Description.