Suspension

Rear Suspension Arm

6steps
~36min
4/5difficulty
Done 0 of 6
Exploded View
1. Rear suspension arm bushing 2. Rear suspension member 3. Rear knuckle
4. Ball joint seat 5. Cotter pin 6. Stabilizer connecting rod
7. Rear suspension arm Front
Removal and Installation

REMOVAL

Remove the rear wheel and tire using power tool. Refer to Removal and Installation.

Support the rear lower link with a suitable jack.

Remove bolt (1) and separate the rear wheel sensor from the knuckle. Refer to Exploded View.

For AWD Nissan Murano vehicles, remove the rear drive shaft. Refer to Removal and Installation.

Remove the stabilizer. Refer to Removal and Installation.

Remove the cotter pin from the rear suspension arm stud.

Remove the rear suspension arm nut from the rear knuckle using power tool. Separate the rear suspension arm from the rear knuckle.

If necessary, remove ball joint seat.

Remove the rear suspension arm nuts and bolts from the rear suspension member using power tool.

Remove the rear suspension arm.

If necessary, remove the rear suspension arm bushings.

INSPECTION AFTER REMOVAL

Ball Joint Inspection

Manually move ball joint to confirm it moves smoothly with no binding.

Swinging Torque Inspection

  1. Move ball joint at least ten times by hand to check for smooth movement.

  2. Hook Tool (A) on ball joint at pinch bolt location. Confirm measurement value is within specifications when ball joint begins moving.

    Tool number : – (J-44372)
    Swinging torque : Refer to Ball Joint.
    • If swinging torque exceeds standard range, replace rear suspension arm.

Rotating Torque Inspection

  1. Move ball joint at least ten times by hand to check for smooth movement.

  2. Confirm measurement value is within specifications when ball joint begins rotating.

    Rotating torque : Refer to Ball Joint.
    • If rotating torque exceeds standard range, replace rear suspension arm.

Axial End Play Inspection

  1. Move ball joint at least ten times by hand to check for smooth movement.

  2. Move tip of ball joint in axial direction to check for looseness.

    • If there is axial end play, replace rear suspension arm.

INSTALLATION

Installation is in the reverse order of removal.

  • Install the rear wheel sensor to the rear knuckle. Refer to Removal and Installation.

  • Perform the final tightening of the parts under unladen conditions with tires on level ground.

  • Check the wheel alignment. Refer to Inspection.

  • Adjust the neutral position of the steering angle sensor. Refer to Description.

  • For AWD Nissan Murano vehicles, check the rear differential gear oil level. Refer to Inspection.