Suspension

Rear Shock Absorber

~1min read
Exploded View
1. Rear shock absorber 2. Piston rod lock nut 3. Shock absorber insulator
4. Bound bumper Front
Removal and Installation

REMOVAL

Remove the rear wheel and tire using power tool. Refer to Removal and Installation.

Set a suitable jack under the rear lower link to relieve the coil spring tension.

Remove the lower rear shock absorber bolt (A) using power tool.

Gradually lower the suitable jack to separate the rear shock absorber from the rear lower link.

Remove the rear shock absorber nuts ().

Remove the rear shock absorber.

INSTALLATION

Installation is in the reverse order of removal.

  • Perform the final tightening of the parts under unladen conditions with the tires on level ground.

Disposal

Set the shock absorber horizontally with the piston rod fully extended.

Drill a 2 – 3 mm (0.08 – 0.12 in) hole at the position () as shown to release gas gradually.

(A) : 20 – 30 mm (0.79 – 1.18 in)

Position the drilled hole downward and drain the oil by moving the piston rod several times.