Steering Column
Electric steering column
| 1. | Steering column | 2. | Hole cover | 3. | Lower boot |
| 4. | Steering intermediate shaft |
Mechanical steering column
| 1. | Steering column | 2. | Hole cover | 3. | Lower boot |
| 4. | Steering intermediate shaft |
REMOVAL
Remove the combination switch. Refer to Removal and Installation.
Remove the steering angle sensor from the steering column. Refer to Removal and Installation.
Remove the left knee air bag module. Refer to Removal and Installation.
Disconnect the harness connectors from the tilt and telescopic motor (if equipped).
Remove the nut and bolt and separate the steering intermediate shaft from steering column.
Remove the steering column nuts and bolt then remove the steering column.
INSTALLATION
Installation is in the reverse order of removal.


After installation, turn steering wheel to make sure it moves smoothly while turning to the left and right stops. Make sure the number of turns are the same from the straight-forward position to the left and right stops. Make sure that the steering wheel is in a neutral position when driving straight ahead.
After installing the steering column, check the tilt mechanism for proper operation.
Adjust the neutral position of the steering angle sensor. Refer to Description.