Steering Gear and Linkage

| 1. | Outer socket | 2. | Inner socket lock nut | 3. | Small boot clamp |
| 4. | Boot | 5. | Large boot clamp | 6. | Inner socket |
| 7. | Spacer | 8. | Rack bar (not serviceable) | 9. | Bracket |
| 10. | Steering gear |
REMOVAL
Remove front wheel and tire using power tool.
Loosen inner socket lock nut (A).

Remove cotter pin from outer socket.
Loosen outer socket nut and separate outer socket from steering knuckle using suitable tool.
Remove outer socket nut and outer socket.
INSTALLATION
Install outer socket to inner socket.

Adjust inner socket to standard length (L), and then tighten inner socket lock nut to the specified torque. Refer to Exploded View. Check length of inner socket (L) again after tightening inner socket lock nut. Make sure that the length is the standard.
| Inner socket length (L) | : Refer to Steering Gear. |
Install outer socket to steering knuckle.
Install outer socket nut to outer socket. Refer to Exploded View.
Install cotter pin to outer socket stud hole.
Install front wheel and tire. Refer to Removal and Installation.
Check wheel alignment. Refer to Wheel Alignment (Unladen1).
Adjust the neutral position of the steering angle sensor. Refer to Description.
REMOVAL
Remove outer socket. Refer to Removal and Installation - Outer socket.
Remove inner socket lock nut.
Remove small boot clamp and large boot clamp.
Remove boot.
INSTALLATION
Install large end of boot (1) to gear housing.

Apply silicone grease between the inner socket and small end of boot (2). Install small end of boot to inner socket boot mounting groove.
Install small boot clamp.

Install large boot clamp using Tool.
| Tool number | : KV40107300 (J-51751) |
Partially thread the inner socket lock nut on the inner socket.
Install the outer socket. Refer to Removal and Installation - Outer socket.
Check wheel alignment. Refer to Wheel Alignment (Unladen1).
Adjust the neutral position of the steering angle sensor. Refer to Description.
REMOVAL
Remove boot. Refer to Removal and Installation - Boot.
Remove inner socket.

Remove spacer.
INSTALLATION
Place spacer on the end of the rack bar.
Apply medium strength thread locker to threads of inner socket. Tighten inner socket to the specified torque. Refer to Exploded View.

Install boot. Refer to Removal and Installation - Boot.
Check wheel alignment. Refer to Wheel Alignment (Unladen1).
Adjust the neutral position of the steering angle sensor. Refer to Description.