Driver Information & Multimedia

U0428 Steering Angle Sensor

7steps
~42min
2/5difficulty
Done 0 of 7
DTC Description

DTC DETECTION LOGIC

DTC No.

CONSULT screen terms

(Trouble diagnosis content)
DTC detection condition
U0428

ST ANGLE SENSOR CALIBRATION

(Steering angle sensor calibration)
Diagnosis condition When ignition switch is ON
Signal (terminal) —
Threshold —
Diagnosis delay time —

POSSIBLE CAUSE

  • Neutral position adjustment of steering angle sensor is not complete

  • Steering angle sensor

FAIL-SAFE

  • Predicted course line is not displayed

  • MOD (Moving Object Detection) function is stopped

DTC Confirmation Procedure

CHECK DTC PRIORITY

If DTC U0428 is displayed with DTC U1232, first perform the diagnosis for DTC U1232.

Is DTC U1232 detected?

YES>>

Proceed to DTC Description.

NO>>

GO TO 2.

PERFORM DTC CONFIRMATION PROCEDURE

CONSULT

  1. Ignition switch ON.

  2. Select “Self Diagnostic Result” mode of “AVM” using.

  3. Check DTC.

Is DTC U0428 detected?

YES>>

Proceed to DTC Diagnosis Procedure.

NO>>

To check malfunction symptom before repair: Intermittent Incident.

NO>>

Confirmation after repair: Inspection End.

Diagnosis Procedure

ADJUST THE NEUTRAL POSITION OF THE STEERING ANGLE SENSOR

When U0428 is detected, adjust the neutral position of the steering angle sensor.

Adjust the steering angle sensor neutral position on ABS actuator and electrical unit (control unit) side. Refer to Work Procedure or Work Procedure.

>>

GO TO 2.

PERFORM DTC CONFIRMATION PROCEDURE

CONSULT

  1. Ignition switch ON.

  2. Erase DTC.

  3. Select “Self Diagnostic Result” mode of “AVM”.

  4. Check DTC.

Is DTC U0428 detected?

YES>>

Replace steering angle sensor. Refer to Removal and Installation or Removal and Installation.

NO>>

Inspection End.