Driver Information & Multimedia
U1010 Control Unit(can)
In this manual: Driver Information & Multimedia
7steps
~42min
2/5difficulty
Done 0 of 7
DTC DETECTION LOGIC
| DTC No. | CONSULT screen terms (Trouble diagnosis content) | DTC detection condition | |
|---|---|---|---|
| U1010 | CONTROL UNIT(CAN) [Control unit(CAN)] |
Diagnosis condition | When ignition switch is ON |
| Signal (terminal) | — | ||
| Threshold | — | ||
| Diagnosis delay time | — | ||
POSSIBLE CAUSE
Around view monitor control unit
FAIL-SAFE
—
PERFORM DTC CONFIRMATION PROCEDURE
CONSULT
Ignition switch ON.
Select “Self Diagnostic Result” mode of “AVM”.
Check DTC.
Is DTC U1010 detected?
YES>>Proceed to DTC Diagnosis Procedure.
NO>>To check malfunction symptom before repair: Intermittent Incident.
NO>>Confirmation after repair: Inspection End.
PERFORM DTC CONFIRMATION PROCEDURE
CONSULT
Ignition switch ON.
Erase DTC.
Select “Self Diagnostic Result” mode of “AVM”.
Check DTC.
Is DTC U1010 detected?
YES>>Replace around view monitor control unit. Refer to Removal and Installation.
NO>>Inspection End.
Was this page helpful?