Driver Controls

Washer Tank

~1min read
010203040504.53N·mlb·ft
Tightening torque found on this page
Exploded View
1. Washer tank inlet 2. Seal 3. Washer tank
A. Refer to Installation.
Removal and Installation

REMOVAL

Remove the front combination lamp (RH). Refer to Removal and Installation.

Using a suitable tool, remove clip (A) from the radiator core support and remove the washer tank inlet (1) from the washer tank.

Disconnect harness connector from the front and rear washer motor.

Disconnect harness connector from the washer fluid level switch.

Release the harness from the washer tank.

Disconnect the front and rear washer tubes from the front and rear washer motor.

Remove the washer tank bolts and washer tank.

INSTALLATION

Installation is in the reverse order of removal.

Washer tank bolts : 4,5 N·m