Hyundai Sonata LF Quiz
Body Electrical System

Automatic Headlamp Leveling Device Repair Procedures

In this manual: Body Electrical System
General Information — 9Engine Mechanical System — 90Engine Electrical System — 58Emission Control System — 24Engine Control System/Fuel System — 114Drive Shaft and Axle — 15Suspension System — 35Steering — 19Restraints — 50Brake System — 54Body (Interior and Exterior) — 213Body Electrical System — 241Heating, Ventilation, and Air Conditioning — 56DCT (Dual Clutch Transmission) System — 52
11steps
~66min
3/5difficulty
Done 0 of 11

Inspection

  1. Ignition switch ON.
  2. Turn on the headlamp switch.
  3. Check for proper operation. The headlamp angle should change smoothly when the headlamp leveling switch is turned.
  4. If the system does not operate properly, inspect the connector and terminals to make sure they are making good contact. If the terminals are bent, loose, or corroded, repair them as necessary and recheck the system. If the terminals appear normal, go to step 5.
  5. Replace with a known-good headlamp assembly and check for proper operation.

Removal

  1. Disconnect the negative (-) battery terminal.
  2. Disconnect the headlamp leveling actuator connector.
  3. Remove the headlamp leveling unit link (A).
  4. Remove the headlamp leveling unit.

Installation

  1. Install the headlamp leveling device.
  2. Connect the headlamp leveling device connector.

Test yourself

A quick Hyundai Sonata LF quiz: every answer comes with an explanation and a link to the manual page.