Curtain Airbag (CAB) Module Repair Procedures

Removal

1. 1
   Disconnect the negative battery cable and wait at least 3 minutes before starting work.
2. 2
   Remove the roof headlining. (Refer to Body - "Roof Headlining Assembly")
3. 3
   Disconnect the curtain airbag harness connector.

   

4. 4
   After loosening the mounting bolts and nuts, remove the curtain airbag.

   

Installation

1. 1
   Remove the ignition key from the vehicle.
2. 2
   Disconnect the negative battery cable and wait at least three minutes.
3. 3
   Tighten the curtain airbag mounting bolts and nuts.

   Tightening torque: 6.9 ~ 8.8 N·m

   Never twist the airbag module during installation. If the airbag module is twisted, the airbag module may not operate properly.

4. 4
   Connect the curtain airbag connector.
5. 5
   Install the roof trim. (Refer to Body - "Roof Trim Assembly")
6. 6
   Connect the negative battery cable.
7. 7
   After installing the curtain airbag (CAB), check that the system operates correctly:

   A.	Turn the ignition ON; the SRS indicator should illuminate for approximately six seconds, then turn off.