Front Seat Cushion Cover Repair Procedures

Replacement

Wear gloves to protect your hands.

When prying with a flat-tip screwdriver or a trim tool, wrap the tool with protective tape and apply protective tape to the surrounding parts to prevent damage. Use a plastic panel removal tool to remove the interior trim parts so as not to damage the surface. Be careful not to bend or scratch the trim and panels.

1. 1
   Remove the front seat assembly. (Refer to Front Seat - "Front Seat Assembly")
2. 2
   Remove the front seat outer cover. (Refer to Front Seat - Front Seat Outer Shield Cover)
3. 3
   Remove the front seat inner shield cover. (Refer to Front Seat - Front Seat Inner Shield Cover)
4. 4
   Loosen the retaining clip and screws, then remove the front seat lower cover (A).

   

5. 5
   Disconnect the connectors (A).

   

6. 6
   Remove the front seat cushion ventilation duct (A).

   

7. 7
   Pull the protectors (A), then pull the front seat cushion cover off the front seat cushion frame (B).

   

8. 8
   Remove the front seat cushion cover (A) from the front seat cushion frame.

   

9. 9
   Remove the hook-and-loop fastener (A) and clips (B) on the front of the seat back, then remove the front seat back trim (C).

   Make sure the foam wire does not come off its position.

   

10. 10
    Install in the reverse order of removal.

    To prevent wrinkles, make sure the material is evenly stretched over the cover (B) before installing the clips (A).