Hyundai Sonata LF Quiz
Drive Shaft and Axle

Rear Hub Assembly - Repair Procedures

In this manual: Drive Shaft and Axle
General Information — 9Engine Mechanical System — 90Engine Electrical System — 58Emission Control System — 24Engine Control System/Fuel System — 114Drive Shaft and Axle — 15Suspension System — 35Steering — 19Restraints — 50Brake System — 54Body (Interior and Exterior) — 213Body Electrical System — 241Heating, Ventilation, and Air Conditioning — 56DCT (Dual Clutch Transmission) System — 52
8steps
~48min
2/5difficulty
04080120160200107.880N·mlb·ft
Tightening torque found on this page
Done 0 of 8

Replacement

  1. Raise the vehicle and make sure it is securely supported.
  2. Remove the wheel cap (A).
    Be careful not to damage the wheel cap (A) when removing it.
  3. Remove the front wheel and tire (A) from the front hub.

    Tightening torque: 88.2 ~ 108 N·m
    Be careful not to damage the hub bolts when removing the front wheel and tire (A).
  4. Remove the brake caliper mounting bolts, then hang the brake caliper assembly (A) with wire.

    Tightening torque: 78.4 ~ 98 N·m

    [General]
    [EPB]
  5. Loosen the mounting screw, then remove the brake disc (A).

    Tightening Torque: 4.9 ~ 5.8 N·m

  6. Disconnect the rear wheel speed sensor connector (A).
  7. Loosen the mounting bolts and remove it.

    Tightening torque: 58.3 ~ 69 N·m

  8. Install in the reverse order of removal.

Test yourself

A quick Hyundai Sonata LF quiz: every answer comes with an explanation and a link to the manual page.