Rear Hub - Carrier Repair Procedures

Removal

1. 1
   Raise the vehicle and make sure it is securely supported.
2. 2
   Remove the wheel cap (A).

   

   Be careful not to damage the wheel cap (A) when removing it.

3. 3
   Remove the front wheel and tire (A) from the front hub.

   Tightening torque: 88.3 ~ 108 N·m

   

   Be careful not to damage the hub bolts when removing the front wheel and tire (A).

4. 4
   Remove the brake caliper mounting bolts, then hang the brake caliper assembly (A) with wire.

   Tightening Torque: 78.5 ~ 98 N·m

   [General]

   

   [EPB]

   

5. 5
   Loosen the mounting screw, then remove the brake disc (A).

   Tightening Torque: 4.9 ~ 5.8 N·m

   

6. 6
   Loosen the rear upper arm mounting bolt and remove the rear upper arm (A).

   Tightening torque: 137.3 - 157 N·m N·m (14.0 - 16.0 kgf·m, 101.3 - 115.7 ft-lbf)

   

7. 7
   Disconnect the rear wheel speed sensor connector (A).

   

8. 8
   Disconnect the parking cable retainer clip (A), then remove the parking cable (B). If equipped with EPB, release the EPB.

   

9. 9
   Loosen the trailing arm mounting nut (A), then remove the trailing arm (B).

   Tightening torque: 98.1 ~ 118 N·m

   

10. 10
    Loosen the bolt and remove the auxiliary arm.

    Tightening torque: 137.3 - 157 N·m N·m (14.0 - 16.0 kgf·m, 101.3 - 115.7 ft-lbf)

    

11. 11
    Loosen the lower arm mounting bolts (A), then remove the knuckle assembly (B).

    Tightening torque: 137.3 - 157 N·m N·m (14.0 - 16.0 kgf·m, 101.3 - 115.7 ft-lbf)

    

12. 12
    Loosen the hub bearing retainer, then remove the hub bearing (A) from the knuckle.

    

13. 13
    Install in the reverse order of removal.